Click to enlarge image


BEAM PRESSES:





S3 Series

Model Cutting Power (US tons) Working Area (mm) Stroke (mm) Max. Daylight (mm) Cutting Speed (mm/sec)
S325 27 1600x600 350 400 340-65-345
S377/1 77 1600x800 300 325 251-24-258
S3110/1 110 1600x1050 300 325 251-17-216
S3110/2L 110 2000x1320 300 325 251-17-216
Click to enlarge image






S6 Series

Model Cutting Power (US tons) Working Area (mm) Stroke (mm) Max. Daylight (mm) Cutting Speed (mm/sec) Motor (Kw)
S677/1 77 1600x800 200 230 251-24-261 5.5
S6110/1 110 1600x1050 200 230 251-17-216 7.5
S6110/2L 110 2000x1320 200 230 251-17-216 7.5
S6165/1 165 1600x1050 130 175 167-11-144 7.5


With the moveable beam of the S3 series or the sliding tray of the S6 series, a cutting power range varying from 20 up to 150 tons, these are the basic equipment for industrial cutting at low cost. A wide range of uses: from the cutting of components for car industry, up to gaskets, filters, packing, abrasives, foam, rubber, soundproofing materials, toys, leather goods, etc.

Efficiency and reliability guaranteed by the RELCO/ATOM trade marks. Click to enlarge image





BP Series

Model Cutting Power (US tons) Working Area (mm) Stroke (mm) Max. Daylight (mm) Cutting Speed (mm/sec)
S677/1BP 77 1600x800 200 230 251-24-261
S6110/1BP 100 1600x1050 200 230 251-17-216
S6110/2LBP 100 2000x1320 200 230 251-17-216
S6165/1BP 165 1600x1050 135 140 167-11-144

Powerful, accurate and quick, the BP versions with "hold and drag" pincers and transport and cutting belt allow the continuous cutting (up to 20 strokes per minute) of the whole width of materials in rolls - in sheets as well thanks to a special program - to get the best performance as far as cutting speed/material yield. Click to enlarge image









RH Series

Model Cutting Power (US tons) Working Area (mm) Stroke (mm) Max. Daylight (mm) Cutting Speed (mm/sec)
S677/1RH 77 1600x800 200 230 251-24-261
S677/2RH 77 2000x800 200 230 251-24-261

The RH versions are the answer to specific demands (such as cutting of leather goods, or when it is necessary to center the die on particular points of the material) where the total visibility on the working area is a must. In comparison with other solutions available on the market, we offer you the ATOM quality, higher advancing/receding speed of the beam and easier, quicker adjustments.